Plate Fin Heat Exchangers

Aluminum Plate And Fin Heat Exchanger / Compact heat exchangers

 
 
Quick Detail:

 
 
1. Specifications

   Oil connector us the 5A02 material

   First tank with tank height 70mm, width 140mm

   Alloy aluminum row use the type 5A02 with chamfer 3*45°

   Core outside fin 140*927 95 wavy 3002

   Inner fin 18 mm*950mm*30mm serrated 3002/50

   Cover Plate 5mm * 140mm * 950mm  3A21

   Short bar 3mm * 6mm * 950mm (D Type)

2. Description:

1) This oil cooler was referred to the standard of JB/T7261-94 aluminum plate- fin heat exchanger                  technical document granting condition.

2) Thoroughly welding at the alleyway of inner fin, guarantee the surface was clean and without any air-          hole or crack, finished with nice surface.

3)  Interior alleyway must bear the pressure of 5.0 Mpa water test, 10mintues water test without no                  deformation or leakage. Then, 1.6Mpa gas tightness test, 30minitues without deformation or any                leakage.

4) No any damage or scratch on the surface of the core, keep aluminum fins are modified.

    Plastic cap should be put on the tube mouth 

 
 
 
Supplier Charastics:
 
1) We obtained skilled drawing worker in design and creating drawings.
 
2) Reliable facility: We can make heat exchanger with large capacity.
 
3) Quick Sample:We can give out sample within 10 days,but the shipment charge usually paid by buyer.

4) As a export enterpries, we are full of experience in delivery and international logistics.
 
5) Rapid response to your requirments: Quick response within 24 hours.